![]() I cut a 14 cable flat (grey) cable to length, removed 2 cables from it then split it in half for 2 6-cable flat cables. They were wrapped around each switch leg for stability and safety. The end result isn't perfect but it's faster and better than not doing it. If it's too short I strip some more and push down. ![]() ![]() If it's too long, I strip some more of the plastic coating and push it back up. Next I solder it on, strip a piece of plastic further up and push it down along the cable until it's a good length between the diodes. I did find an easier and faster way of cutting off the plastic cover from the cable, where I cut off a longer piece of cable than I need, then strip a sizeable length. The first and last diode was wrapped an entire lap around the cable, the middle ones were simply folded over the cable before solder was added.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |